Warranty• DuraTrax™will warranty this kit for 90 days after the purchase date from defects in materials or workmanship. DuraTraxwill either repair or
10❏ 22. Re-install the radio box back onto the chassis.Use the (8) 3x15mm flathead self tapping screws thatyou removed earlier to secure the radio box
❏ 29. Remove the servo horn from the throttle servo.Enlarge the two farthest holes at one end of the hornand the farthest hole on the other end with a
12❏ 35. Snap the ball cup onto the throttle. Install asecond rod collar onto the throttle linkage so that it fitsagainst the rod connector. Note: Do n
❏ 42. Press the “L” shaped boot onto the bottomhousing of the air filter. Using one of the included tie-straps, secure the boot onto the bottom housin
14❏ 48. Remove the throttle and steering servo hornsfrom the servos. Turn on the transmitter, then turn onthe receiver. Center the trims on the transm
The High-Speed NeedleThe “high-speed” needle is sticking up from the side ofthe carb. It is located in the brass housing, just abovethe fuel inlet. It
16If the engine does not start after several pulls,sometimes it is helpful to start the engine at aroundhalf throttle. Have a friend pull back on the
8. Do not scratch the piston or cylinder sleeve. Avoidjamming something into the exhaust port whenremoving or re-installing the clutch or flywheel.Use
18Toe-In/Toe-Out: This refers to the angle of the fronttires when viewed from above when the suspensionarms are level. If the fronts of the tires angl
19ENGINE TROUBLE SHOOTINGThe engine startsDoes the engineturn over easily?Does it runcontinuously?Is fuel getting tothe engine?Check for clogging inth
2Introduction...2Safety Precautions ...
20RECOMMENDED ACCESSORIESDuraTrax 4-Shoe Clutch KitTweak your Axis for amazing acceleration!This kit increases surface area compared to 3-shoe clutch
Repair service is available anytime. • After the 90 day warranty, you can still have your Axisrepaired for a small charge by the experts at DuraTrax’s
4❏ 1. Remove the buggy, transmitter and parts fromthe box.❏ 2. Remove the twist-tie from the receiver antennawire. The receiver wire looks like a bund
❏ 7. Remove the receiver battery holder from theradio box. Install (4) “AA” batteries (included) into thebattery holder in the configuration molded in
6❏ 1. Remove the Axis buggy and the transmitter fromthe box.❏ 2. Remove the radio tray from the chassis byremoving the (8) 3x15mm flat head self tappi
❏ 4. Use a hobby knife or diagonal cutters to removethe servo mounting blocks from the radio tray. Makesure all of the flashing is removed from inside
8❏ 10. Install the servo horn onto the throttle servo,note the direction of the servo horn. Secure thehorn to the servo with the screw included with t
❏ 16. Install 4 “AA” batteries into the receiver batteryholder in the configuration molded into the batteryholder included with the radio system.❏ 17.
Kommentare zu diesen Handbüchern